Double Rubber
Purpose
This is a 3D printable file for the double rubber as presented in the build manual. The widths of the tenons and mortice where slightly adjusted to fit my t-tracks so you might need to check that also. I designed this to be printed in resin though I am sure with the approriate support marterial and post-processing, this could be printed on an FDM printer. I printed a batch on-end in PLA style resin and they came out fine. I put a hole in the end for a pinion that would support a bearing whose clearance channel was intended to be machined out, however I've not tried that yet. I'm guessing the success of that will depend on the type of resin used.
Designed by Kevin Hazeldine for the MDF Rose Engine.
Slicer Notes
|
Item |
Setting |
Comments |
|
Wall loops |
3 |
Need extra wall thickness for the rubbed edge |
|
Infill |
30% |
Need to be rugged enough |
Files
Fusion 360 F3D File
Parameterised Fusion 360 project file - Rubber-DoubleRubber.f3d
|
|
|
|
|
|
eMail comments to me at ColvinTools @ Gmail.com