************** Purpose **************
Purpose
These are used to make designs on the curvilinear slide. They are the part shown in yellow in the picture to the right.
These go with the curvilinear slide outlined in this manual: Jigs, Fixtures, & Add-Ons: Volume 2.
************** Files **************
Files
The STL files needed to make the pre-defined shapes are below.
Unless otherwise noted,
- The overall size for each is 7” long x 1/8” thick
- The edge where the curvilinear's follower rubs has a 0.05” radius on top & bottom.
*************************************************
****************** 101 & 102 ********************
|
| 101 & 102
Curv_Tmplt-101-102.stl
Curve has a 6” radius.
|
*************************************************
****************** 111 & 112 ********************
|
| 111 & 112
Curv_Tmplt-111-112.stl
Curve has a 8” radius.
|
*************************************************
****************** 121 & 122 ********************
|
| 121 & 122
Curv_Tmplt-121-122.stl
Curve has a 10” radius.
|
*************************************************
****************** 131 & 132 ********************
|
| 131 & 132
Curv_Tmplt-131-132.stl
Curve has a 12” radius.
|
*************************************************
****************** 141 & 142 ********************
|
| 141 & 142
Curv_Tmplt-141-142.stl
Curve has a 14” radius.
|
*************************************************
****************** 151 & 152 ********************
|
| 151 & 152
Curv_Tmplt-151-152.stl
Curve has a 17” radius.
|
*************************************************
****************** 161 & 162 ********************
|
| 161 & 162
Curv_Tmplt-161-162.stl
Curve has a 21” radius.
|
*************************************************
****************** 171 & 172 ********************
|
| 171 & 172
Curv_Tmplt-171-172.stl
Curve has a 3” radius.
|
*************************************************
****************** 181 & 182 ********************
|
| 181 & 182
Curv_Tmplt-181-182.stl
Curve has a 4” radius.
|
*************************************************
****************** 191 & 192 ********************
|
| 191 & 192
Curv_Tmplt-191-192.stl
Curve has a 5” radius.
|
*************************************************
****************** 201 & 202 ********************
|
| 201 & 202
Curv_Tmplt-201-202.stl
Both curves have 8" radii.
|
*************************************************
********************* 901 ***********************
|
|
901 Flipped 180°
901
Curv_Tmplt-901.stl
Can also be flipped 180° as shown to the right, and used that way.
|
************** Comments **************
Comments
(comments regarding this part)
########## Standard Footer for all pages ##########
eMail comments to me at ColvinTools @ Gmail.com
